Installing a Plug-in

Installing a Plug-in

1. Log in to the management console.
2. Click in the upper left corner of the page, select a region, and choose Security > Host Security Service. The HSS page is displayed.
3. In the navigation pane on the left, choose Installation & Configuration > Plug-in Settings. Click Plug-In Installation Guide. In the slide-out panel, copy the commands in the Installation Commands section.
4. Remotely log in to the server where the plug-in is to be installed as the root user.
   • You can log in to the ECS management console and click Remote Login in the ECS list.
   • If your server has an EIP bound, you can also use a remote management tool, such as PuTTY or Xshell, to log in to the server and install the plug-in on the server as user root.

5. Run the following command to access the /tmp directory:

   cd /tmp/
   
   

6. Create linux-host-list.txt, which will contain the server private IP addresses where the agent is to be installed:

   Command syntax:

   echo 127.8.8.8 22 root rootPassword >> linux-host-list.txt
   
   

   Or
   echo 127.8.8.8 22 user userPassword rootPassword >> linux-host-list.txt
   
   

   To specify multiple IP addresses, write multiple commands, each in a separate line.

   Example:

   echo 127.8.8.1 22 root rootPassword >> linux-host-list.txt
   echo 127.8.8.2 22 user userPassword rootPassword >> linux-host-list.txt
   echo 127.8.8.3 22 root rootPassword >> linux-host-list.txt
   
   

7. Press Enter to save the IP address. Run the cat linux-host-list.txt command to verify the IP addresses have been added.
8. Copy the batch installation commands to the command terminal and press Enter.
9. If remote_install finished. [OK] is displayed, the installation is successful. Wait for 3 to 5 minutes and check the Docker plug-in status of the panel server.